There is a backdoor CLI for the SGE/SFE2000/2010 switches. However, the feature is unsupported and not recommended to use. Additionally, if you enable the CLI view on the console, there is not an exit command to go back to the menu driven supported configuration.
To access this configuration you can telnet to the switch (if you enable Telnet under the Bonjour tab) or console the switch. Authenticate as you normally would.
Press ctrl+z at the same time then type LCLI and hit enter. This will toggle the CLI and a 'normal login'.
Please mark answered for helpful posts
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...