i've recently bought a SGE2010-G5 48 Ports Workgroup switch. The first thing I did was to give the device a static IP Address, 188.8.131.52, with the default gateway 184.108.40.206. Than I used a webbrowser to configure the switch, which included an upgrade to the latest firmware (220.127.116.11). After a reboot (to activate the latest firmware), the IPV4 settings were gone , and also the users that I've created, so I had to start all over again. Also I'm affraid that after a power failure I have to configure all settings again, because it looks like the settings are not stored permanent.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...