Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configure SG300 to work like an unmanaged switch

Hi!

How do i have to configure the SG300 so that it acts like any other completely unmanaged Switch. 

I dont want to configure any vlans on the sg300. It should just work like there wouldnt be a sg300, but an unmanaged switch.

The story behind:

I want to use a SG300-28P as POE-Switch for FortiAP-Access Points, but it doesnt work out of the box cause FortiAP receives and sends some tagged and untagged VLAN-traffic.

Everything works, if i use a cheaper, unmanaged POE-Switch, but i cant get it to work if i use a SG300.

Thanks for any help.

Tom

 

 

 

 

 

 

 

Everyone's tags (2)
4 REPLIES

I would try disabling CDP,

I would try disabling CDP, LLDP and auto smart ports.  All are enabled by default I think.

-- please remember to rate and mark answered helpful posts --
New Member

Thanks for your help. After

Thanks for your help. After disabling CDP and LLDP it started working.

 

 

Thanks for following up.

Thanks for following up.  Good to know that worked.

-- please remember to rate and mark answered helpful posts --
New Member

I am having the exact same

I am having the exact same issue (except with Meraki APs).

Out of the box, I disabled LLDP, CDP, and Smartport, but I'm not having the success that you had.

Anything else I need to do? Set the ports to General instead of Trunk?

1865
Views
0
Helpful
4
Replies
CreatePlease to create content