Configure SG500-P28 as default route of 2 network with same subnet ID
I have 2 networks with same subnet ID. I would like to how to configure the SG 500-P28 for make communication between these two network. I don't have background of Networking so i am using the GUI for configuring the router.
Host IP 192.168.21.2 till 30
Host IP 192.168.21.130
I think, i am using the right gateway. Please advice. Thanks in advance!
Yes you should have 2 different subnets with separate gateways , the sg500 is a layer 3 device so it can route between the 2 subnets no problem doing intervlan routing , use a 192.168.22.x/24 or something similar to what you have already , when you have 2 different gateway's set for same subnet the packets may end up getting dropped half the time losing large amount of traffic for you
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...