Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

default interface command for SG50052

Hello 

I am trying to set an interface back to its defaults but with no success at all. Actually is a trunk interface and I want to make it access again. With no switchport mode and then switchport mode trunk I get a message about wrong VLAN assignments.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Hi,Configure as below

Hi,

Configure as below:

switchxxxxxx(config)# interface gi1

switchxxxxxx(config-if)# no switchport mode trunk
switchxxxxxx(config-if)# switchport mode access
switchxxxxxx(config-if)# switchport access vlan 2(required vlan number)

 

regards

Moorthy

2 REPLIES
Bronze

Hi,Configure as below

Hi,

Configure as below:

switchxxxxxx(config)# interface gi1

switchxxxxxx(config-if)# no switchport mode trunk
switchxxxxxx(config-if)# switchport mode access
switchxxxxxx(config-if)# switchport access vlan 2(required vlan number)

 

regards

Moorthy

New Member

Hello Moorthy Thanks for your

Hello Moorthy 

Thanks for your reply. When I enter the no switchport mode trunk I get the % Wrong number of parameters or invalid range, size or characters entered message.

82
Views
0
Helpful
2
Replies