Hello!! i a facing a certain problem and i would be grateful if someone could help me.
as show in the network photo, my main switch is the dhcp server. i have many vlans configured on my network. the problem is that i created a new vlan for the voip phone (vlan 50) and i want the switch 2 to be the dhcp server for this vlan...i enabled dhcp server, i created the network pool but the phone doesn't get the ip from vlan 50...
i spotted a difference between the 2 switches.
the main switch is 52 port without poe and it has on the ip configuration folder more menus (ex dhcp relay, ipv4 routes) whereas the sg500-52p (poe) doesn't have them...
i did some research and i found that maybe the problem is that the poe switch doesn't support ip dhcp relay...therefor my voip phone cannot obtain an ip because it is on a different vlan from the poe switch...is that correct?
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...