I have an SG300. I have two ports on vlan 20 which is subnet 172.20.20.0/24. The laptop I have needs to get it's DHCP address from the device that is connected to one of the two ports on vlan 20. However the laptop that is connected to one of the ports is getting its dhcp address from the switch so it's getting an ip from 22.214.171.124/24 which is vlan 1. Of course I need it to be on the subnet associated with vlan 20 which is 172.20.20.0/24. I am brain dead. What am I needing to configure so that vlan 20 doesn't get an IP address from vlan 1 subnet 192.168.0.0/24?
3. I am not using the switch for dhcp for the 172.20.20.0 subnet. It's coming from the Netgate that the laptop is connected. I'd like it so that nothing on the 172.20.20.0 subnet responds to DHCP from the DHCP server especially considering I don't have it configured for that subnet.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...