Yes I did get it sorted but mainly through trial and error and it was some time ago. I seem to remember that there is an option for dhcp in the menu structure and I had to make changes in two fields. I'm sorry I don't remember any more than that & don't have access to the boxes now.
Just to let you know, my problem was not with the switch, but the DHCP server which had an application that was hijacking the bootp port ... So the switch was doing the right thing all along, but server was not responding except on VLAN 1.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...