Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

DHCP server cannot be configured. To enable the DHCP server, remove DHCP clients on all interfaces.

how do i configure DHCP in Cisco switch SG300 28 PP. when i tried it says " DHCP server cannot be configured. To enable the DHCP server, remove DHCP clients on all interfaces" .

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

go to ipv4 interfaces and

go to ipv4 interfaces and remove the interface vlan in DHCP or configure it in Static IP address

5 REPLIES
Community Member

go to ipv4 interfaces and

go to ipv4 interfaces and remove the interface vlan in DHCP or configure it in Static IP address

Community Member

Hi Can explain about 

Hi Can explain about 

DHCP server cannot be configured. To enable the DHCP server, remove DHCP clients on all interfaces.

Cisco Employee

Hello,

Hello,

As Alain explained above, you need to remove dhcp clients on all interfaces. By default VLAN 1 is set up as a DHCP client, so before you enable DHCP server you will need to either disable dhcp client or assign a static IP to VLAN1.

Thanks,
Kris

Community Member

Yes thanks,

Yes thanks,

Community Member

Ok How can i do it?

Ok How can i do it?

2033
Views
10
Helpful
5
Replies
CreatePlease to create content