Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Does The SG300-10 Support RIP?

Hi!

In the CLI documentation for the SG 300 Series, it shows sh ip route rip as a command. I have installed the latest firmware and that command is no longer available. Does the SG300 series support RIP?

Thanks!

Richard S.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Does The SG300-10 Support RIP?

Hello Richard,

My name is David Aguilar, and I am an engineer with the Cisco Small Business Center. Thanks for writing.

The SG300 Series does not support RIP. Only static routes (maximum of 32) are supported. However, the SG500X models support the RIP version 2 dynamic routing protocol.

In regards to the new Sx300 firmware, it did add a number of impressive security features including IP ARP inspection, DHCP snooping, and SSD encryption.

All the best,

-David Aguilar

Cisco Small Business Support Center

6 REPLIES
New Member

Does The SG300-10 Support RIP?

Hello Richard,

My name is David Aguilar, and I am an engineer with the Cisco Small Business Center. Thanks for writing.

The SG300 Series does not support RIP. Only static routes (maximum of 32) are supported. However, the SG500X models support the RIP version 2 dynamic routing protocol.

In regards to the new Sx300 firmware, it did add a number of impressive security features including IP ARP inspection, DHCP snooping, and SSD encryption.

All the best,

-David Aguilar

Cisco Small Business Support Center

New Member

Does The SG300-10 Support RIP?

Hello,

can I ask you where can I find new 1.2.5 firmware verison? I was unable to find it.

Thank you!

Best wishes,

Marko

Green

Does The SG300-10 Support RIP?

Marko,

The 1.2.5.70 firmware has been pulled by the business unit. Please continue to use the 1.1.2.0 firmware

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

Does The SG300-10 Support RIP?

I knew it was too good to last... Will it be added back?

Green

Does The SG300-10 Support RIP?

Marko, please follow this post for updates;

https://supportforums.cisco.com/docs/DOC-25157

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

Does The SG300-10 Support RIP?

Thank you!

Best wishes,

Marko

2983
Views
0
Helpful
6
Replies
CreatePlease to create content