For this you need a switch that supports stacking. That could be a Catalyst 2960-X with the optional stack-module or even an SG500-X from the Small Business-Line.
Or if you don't want to buy new switches you could virtualize the servers and configure VMware without teaming but with both links. The hypervisor takes care of failing over to the second switch if the first one fails.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: