i downloadad a new Firmware for my SLM2024 to my PC from cisco homepage. I used Http service to update the firmware and selected the downloaded file. My switch started to update but then it got stuck. the system led is flashig all the time, all port-leds stopped flashing. after about 2 minutes all pot-leds light up for a second. i tried to reset the swith by pressing the reset button but nothing will stop the flashing "system" led.
old firmware: 1.01 new downloadad firmware: 188.8.131.52 s/n: 7QR00GA01196
Release Date: 06/NOV/2009
Size: 3298.95 KB (3378120 bytes)
is there a way to get my switch back to the old firmware? hardware-reset e.g.?
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...