very randomly the ports on the switch stop working and the only way to get them to work again is by resetting the port. we have cisco ip phones connected to the ports and computers connected to the back of the phone.
what i've notices when the phones or computers stop working is that if i unplug the cable from the switch
the LED on the bottom right corner of the port will remain Lid. if i check the config the port shows "suspended"
could you please let me know a better way to resolve this problem, i don't want to reset my switches every day once or twice a day because this is happening so often
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...