I have a 6 port unmanaged switch feeding my ESW520 24 port switch. I am able to see only 1 of the 5 devices connected to the unmanaged switch. I would appreciate any recommendations of settings that could possibly be causing this anomaly. I have factory reset the ESW520 and can still only see the one device. If I connect the unmanaged switch to a laptop instead of my ESW520 I am able to see all devices on the unmanaged switch.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...