Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ESW520 and WLC2106 Mesh problem

Hi everyone

I have a problem with mesh auth,, the scenario are the next:

       pto1        e1          e2     in                                            

WLC2106<<<<ESW520>>>>1522-rap1 ))))))) ((((((((( 1522-map1

                                                                  (((((((( 1522-map2

                                                                  (((((((( 1522-map3

On ESW520

VLAN 1   Default

VLAN 9  Wireless Mesh

Ports

e1        mode Trunk with 2106   (Vlan 1Untag and 9Tag) Fram Type All Access

e2        mode  Access with RAP1  (Vlan 9 Tag) Fram Type All Access

e3        mode Access with PC monitoring Mesh activity (Vlan 9 Tag) Fram Type All Access

On WLC2106

Interfaces

MGMT= 192.168.9.97   Vlan 9  Pto 1

AP MGMT= 192.168.9.96 Vlan 9  Pto 1

RAP1 to MAP3 range IP= 192.168.9.98 to 192.168.9.101

With this scenario only the RAP join into the WLC, but the other MAPs can`t authenticate into the WLC,,,

But If I connect a Linksys Hub betwen WLC and RAP and Untagged the Interfaces on WLC, the RAP and the 3 MAPs can join succesfully and everything works fine.

I dont know what is the problem with the esw520

I hope, someone can help me

Regards.

351
Views
0
Helpful
0
Replies
CreatePlease to create content