I have an ESW 520 switch that is connected to a 3560 switch.
The 3560 switch is connected to a windows DHCP server.
I need to ensure that dynamic addresses are being sent to clients/workstations connecting to the ESW 520.Those workstations connecting to the 3560switch can obtain dynamic IP addresses but those on the ESW cannot.I have tried all i can to get the workstations behind the ESW get dynamic IP addresses from the Windows Server,but all effort proved abortive.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...