Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EW520-24K9-Unable to log into GUI interface

Can't access the GUI interface of a EW520-24K9 switch. Tried using the serial cable and Ethernet cable with no success. The default IP address of 192.168.10.2, 192.168.10.1 or 192.168.10.254 is not working. Any ideas?

1 REPLY
Bronze

Re: EW520-24K9-Unable to log into GUI interface

- Do you have the ESW connected to a network that has a DHCP server such as UC520? If so you may want to check on the DHCP server what IP address is assigned to ESW 520 (MAC address binding). If its a UC520 - then CCA can discover this for you - note make sure you connect the uplink port on the ESW to the UC520 expansion port

- If the ESW is standalone connected back to back to your PC - have you gone through steps 1 through 8 in Section 2 at the guide below:

http://www.cisco.com/en/US/docs/switches/lan/csbms/esw500/quick_start/guide/ESW_500_Quick_Start_Guide.pdf

- If you are using a console cable - make sure the right settings are configured - check page 49 at link below:

http://www.cisco.com/en/US/docs/switches/lan/csbms/esw500/administration/guide/ESW_500_Administration_Guide.pdf

If you have tried all of the above - can you factory reset the ESW and try one of the above?

2470
Views
0
Helpful
1
Replies
CreatePlease to create content