Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

factory defaults

hello I have 2 SLM248G4PS that i need to set back to the factory defaults,

however i don't have access to the GUI interface, when i try to launch it it won't open because the default gateway was set to an ip that is in use by a device that we can't re-ip.

i need to set those 2 switches back to the defaults and start the config from scratch

thanks

Cris

1 ACCEPTED SOLUTION

Accepted Solutions

Re: factory defaults

hello I have 2 SLM248G4PS that i need to set back to the factory defaults,

however i don't have access to the GUI interface, when i try to launch it it won't open because the default gateway was set to an ip that is in use by a device that we can't re-ip.

i need to set those 2 switches back to the defaults and start the config from scratch

thanks

Cris

Hi Cris,

Try configuringusing console connection see the attached document for step by step procedure !!

Ganesh.H

Remember to rate the helpful post

1 REPLY

Re: factory defaults

hello I have 2 SLM248G4PS that i need to set back to the factory defaults,

however i don't have access to the GUI interface, when i try to launch it it won't open because the default gateway was set to an ip that is in use by a device that we can't re-ip.

i need to set those 2 switches back to the defaults and start the config from scratch

thanks

Cris

Hi Cris,

Try configuringusing console connection see the attached document for step by step procedure !!

Ganesh.H

Remember to rate the helpful post

489
Views
5
Helpful
1
Replies
CreatePlease to create content