I don't think SG200 has CLI so you can't do show mac address-table which would let you find port with certain MAC. See if your GUI has such a view and then you need to first get MAC address and can see what port it is on. You can find MAC in computer settings or maybe from command like arp -a from another machine on same broadcast domain.
-- please remember to rate and mark answered helpful posts --
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...