Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

firmware upgrade failed on linksys-cisco WRV210 router

After a Linksys-Cisco WRV210 firmware upgrade I can't reach the configuration surface by any browsers. I can ping the 192.168.1.1 address successfully, but a can't configure the router. I tried the to use the reset bottom without any success.

Thank's for suggestions to solve the problem.

Zoltan Kocsis

2 REPLIES
VIP Purple

Have you tried both http and

Have you tried both http and https?

I assume you don't have a proxy server configured in your browser.

New Member

Yes, I'v tried both, and no

Yes, I'v tried both, and no proxy server.

I'm almost sure, that the firmware upgrade has failed. The question is: is there any possibilities to perform the firmware upgrade, without using the built in configuration software of the router? 

60
Views
0
Helpful
2
Replies
CreatePlease login to create content