As Asked the config of the switch, when i detach draytek 2860 modem/router from port 10 i will get an ip from the draytek 3100 modem/router? It seems there is a connection between the uplink port 9 & 10, if both routers are connected only port 4/5/6/7 gets a correct ip (10.0.30.0) and port 1/2/3 no ip (should be 10.0.10.0).
config-file-header switchb7f26f v18.104.22.168 / R800_NIK_1_4_194_194 CLI v1.0 set system mode switch
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: