Hi, I have two small business cisco 200 series switches connected through RJ-45 link. NOw, I want to establish a fiber link between the switches on one of my combo ports. I have GLC SX MM and GLC SX MMD module available already in my office. During some study, I came to know that for Cisco small business MGBSX1 is better rather than GLC SX MM. If I use GLC SX MM on my cisco small business switches whether the port comes up or I should go with MGB series transiever modules. I also saw a post which says: " Cisco traditional SFP may be recognized by Cisco Small Business switches and function, but this deployment is not supported by Cisco."
Brother, If you already have the Fibre Modules available, then connect them and test. Always learning by expriment gives more knowledge. Use show inventory raw command to check if Switch is detecting the Fibre Module or Not.
Regarding Compatibility of Different Modules check belo link.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...