Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I get from a menu at login to CLI on a SG300-28 Switch?

I have a SG300-28 and would like to configure through CLI not menu. How do I get to Cli from Menu?

  I am running Boot version 1.0.0.4 and SW version 1.0.0.27, Do I need to upgrade both boot and SW or Just SW?

2 REPLIES
New Member

Re: How do I get from a menu at login to CLI on a SG300-28 Switc

Hi rod3,

Typically SSH/Telnet is disabled by default on devices.  In order to activate it you will need to go through the WEB GUI to Security > TCP/UDP Services and check the boxes that say SSH or Telnet then click apply.

Then using a Terminal program of your choice you can connect to the switch and configure it.  Be advised that the CLI is not exactly the same as regular IOS.

-Trent Good

** Please rate useful posts! **

-Trent Good ** Please rate useful posts! **
Green

Re: How do I get from a menu at login to CLI on a SG300-28 Switc

CLI was not available on the 1.0.0.27. That was the first production release. If you want the CLI a firmware upgrade is mandatory.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
338
Views
0
Helpful
2
Replies
CreatePlease login to create content