I have recently had access to an SGE2010P and can not find a CLI for it. I have searched on the Internet for instructions on how to get there but they just say to select edit in the login screen but there is no edit when I go to the login screen. Can someone please tell me how to get to it?
Re: How do you access the CLI on the SGE2010P switch?
I have a way on which you can get to the command line: Telnet into the switch, then type your user name and password, right after hold the Ctrl -Z tab, soon after you perform these steps you will access to the CLI command line.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...