How do you configure a DHCP server's options for SMB 300 Switches for Auto Configuration?
I am looking for a how to configure a DHCP server for a Cisco SMB 300 series switch to obtain an automatic configuration. Currently i am using a Cisco 1800 router as my DHCP server and the DHCP pool serving the 300 series switch is configured as follows.
ip dhcp pool Cisco_SMB_300
network 192.168.0.0 255.255.255.0
option 66 ip x.x.x.x
option 67 ascii "config-file-name.txt"
dns-server 22.214.171.124 126.96.36.199
** I've also tried option 150 .... "option 150 ip x.x.x.x"
Looking at pcaps, I don't even see a tftp request going the server after the switch obtains an IP via DHCP. The config file format is exactly as obtained from the download backup section (pretty sure its not the issue since i don't see a download attempt). Also, the SMB switch is running the latest firmware image (188.8.131.52)
Looking though the admin guide i did not see specifics on how the DHCP server was to be configure for the auto configuration feature to work. Any help is greatly appreciated.
Configure the PNP Settings on a Switch
The installation of new networking devices or replacement of devices can be expensive, time-consuming, and error-prone when performed manually. Typically, new devices are first sent to...
SG350X, Sx550X: RSPAN Mirrored Packet Loss when Forwarding
February 12, 2017
SG350X: Running Cable Test Via The "Test Cable-Diagnostics Tdr" Command May Provide Unpredictable Results
May 23, 2017