How do you configure a "Voice" VLAN on a SFE1000P ?
I'm trying to connect a PC to a Mitel IP Phone (5212) to a SFE1000P, but I can't figure out how to separate the data and phone VLANs. My current state is having the phone and data in the same untagged VLAN.
On the rest of our network, I use HP Procurves (2610) where I can configure a voice VLAN. The PC data then goes in one VLAN (ex VLAN30) while the phone goes in a different VLAN (VLAN221).
Is there a way to designate a "voice" VLAN using an SFE1000P ?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...