Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

How to access CLI Mode in cisco sf 302-08p 8-port 10/100 Managed switch

Hi,

Can any one help me in how to access the CLI mode in  cisco sf 302-08p 8-port 10/100 Managed switch. I treid the every method they mentioned in the Admininstration guide.I am not able to enter the command debug-mode and comand menu after resetting the default password. After logging in, its directly guiding me to switch main menu.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

How to access CLI Mode in cisco sf 302-08p 8-port 10/100 Manage

Hello Fairooz, Mark,

Thank you for participating in the Small Business support community. My name is Nico Muselle from Cisco Sofia SBSC.

To access the CLI, you need to make sure that the firmware version on your switch is at least 1.1.0.73 or preferrably higher. Then enable telnet or ssh on the switch and when opening either of those sessions or a console session you will see that you are in CLI mode. You can revert to the menu based console using the command menu.

Hope this answers your questions !

Best regards,

Best regards,

Nico Muselle

Sr. Network Engineer - CCNA - CCNA Security

3 REPLIES
New Member

How to access CLI Mode in cisco sf 302-08p 8-port 10/100 Manage

Did you ever have access to CLI mode? I have this switch and I am only aware of the menu mode.

I would also prefer to be able to access a CLI for this switch.

Bronze

How to access CLI Mode in cisco sf 302-08p 8-port 10/100 Manage

Hello Fairooz, Mark,

Thank you for participating in the Small Business support community. My name is Nico Muselle from Cisco Sofia SBSC.

To access the CLI, you need to make sure that the firmware version on your switch is at least 1.1.0.73 or preferrably higher. Then enable telnet or ssh on the switch and when opening either of those sessions or a console session you will see that you are in CLI mode. You can revert to the menu based console using the command menu.

Hope this answers your questions !

Best regards,

Best regards,

Nico Muselle

Sr. Network Engineer - CCNA - CCNA Security

New Member

How to access CLI Mode in cisco sf 302-08p 8-port 10/100 Manage

Hello Nico Musselle

Thanks for your kind advice. I upgraded the firmware to 1.1.2.0, and now i am able to access the CLI.

Best regards.

6118
Views
0
Helpful
3
Replies
CreatePlease to create content