How to forward external traffic to different ports? (SG300-52)
This is my first time configuring a layer 3 switch. We have an SG300-52. I have setup a vlan for our servers. I have assigned an IP range to the vlan (192.168.1.0/24). I've connected our web server to one of the ports in the vlan. How would I set it up so that traffic coming in from one of the WAN ports on TCP port 80 is routed to a specific switch port in the vlan? For example: to allow public internet traffic to reach our web server.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...