Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to remove SLM248G4S from stack

I have 3 SLM248G4S switches in a stack (SW1, SW2, and SW3), and want to pull one out and configure it as a stand alone.

If I just disconnect the stacking ports from SW3 and reconnect the bottom stack port from SW2 to the top one of SW1, the two switches continue to function together fine, but SW3 still seems to think it's part of the stack (still shows #3 on the LED screen) and doesn't work at all.  I cannot even telnet into SW3.

How do I accomplish this?

3 REPLIES

Re: How to remove SLM248G4S from stack

Hi Dean,

The quick start guide , page 3  says on the front panel there is a tiny hole, with only room for a paperclip ;

Reset — Press and hold the Reset Button for less than ten seconds to

reboot the switch. Press and hold the Reset Button for more than ten

seconds to reset the switch’s settings to the factory defaults

This should do the trick

regards Dave

New Member

How to remove SLM248G4S from stack

I appreciate your quick answer, but it was incorrect.  My question was about the SLM248G4S, which has no reset button that I can find.  The link you provided was to a quick start guide for different model switches.

Bronze

How to remove SLM248G4S from stack

Hello Dean

I take it you are refering to the orginal SLM248G4S branded as Linksys. I was not able to find the admin guide directly from the Cisco site as we have replaced the SLM248G4S with an updated hardware revision which did change a few things such as adding a reset button.

Below is a link I was able to find for the admin guide:

http://static.highspeedbackbone.net/pdf/Linksys-SLM248G4S-manual.pdf

I would like to suggest that you use the console port on the switch and make changes there or reset the unit.

727
Views
0
Helpful
3
Replies
CreatePlease login to create content