We have Cisco "SG500X-24P 24-Port Gigabit with 4-Port 10-Gigabit PoE Stackable Managed Switch" which is integrated to Netcool (OSS system). The alarms goes to Netcool is not a problem; but cutomer wants to see the ifDescr in the interface alarm (the alarms we generated is we shutdpown the port TenGig port 1/1/1, alarms goes to Netcool, but customer wants to see the ifDescr in alarm). How can you configure this in Cisco SG500X?
[toc:faq]Introduction: This document describes how to connect SG300 with
Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The specification for STP is
IEEE 802.1D. The main purpose of STP is to e...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...