I want to enbale IGMP Snooping Querying on SGE-20x0P switches. IGMP Snooping is enable on the VLAN but I need IGMP Querying that Multicast traffic only forwarded to port that request udp from IPTV core switch not all ports that assign to IPTV VLAN. How can I do this?
Thanks for your reply Tom, my issue in IPTV network is when port 1 in switch A and port 2 in switch B want to see channel 1 of TV the udp traffic broadcast to all port of that switches on the IPTV vlan, we need to forward traffic to port 1 of switch A and port 2 of switch B only and when the users change the channel the udp of channel only forward to that ports, we have 50 channel that start from 22.214.171.124 to 126.96.36.199 and all of SGE 20x0P switches trunk to 3750
Hi mimdi, I am not sure it is possible to do this one this switch. You may be able to make an ACL and specific the source and destination values for IGMP but this wouldn't have the flexibility you're looking for.
You could also choose the forward all ports for the multicast configuration- but again, this would lack the flexibility.
-Tom Please mark answered for helpful posts
Please mark answered for helpful posts
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...