Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Install SonicPoint through SRW224G4P switch to Sonicwall

I want to install a SonicPoint on an existing SRW224G4P switch.  Sonicwall architecture uses VLAN to support multiple SSID on SonicPoint.  Sonicwall interface X0 attached to port e12 on the switch, and the Sonicpoint on e24, which is PoE enabled.  In this configuration I can see the Sonicpoint is OPERATIONAL  as seen on the sonicwall, so there is some communication between the two.  Additionally, a laptop can see the SSID broadcast, and attach in a “limited” manner, but IPCONFIG shows no IP addresses being set.  Oddly, it Windows Update may have worked overnight in this configuration.  However, I cannot access the LAN or WAN from the laptop. 

Where am I going wrong in the switch VLAN configuration?

I followed guidelines in but this article uses Cisco 2960G to set up VLAN.

Note DHCP service is set up for the two VLANS on the Sonicwall.


     VLAN Mgt >> Create a LAN:

          1 DefaultVLAN Static

          20 SonicpointN Corporate Static

          30 SonicpointN  Guest Static

     VLAN >> Port Settings

          Port e12 TRUNK PVID =1 Ingress Filter Enabled

          Port e24 ACCESS PVID=20 Ingress Filter Enabled


     VLAN >> Ports to LAN

          VLAN=1, Static

               Port e12 Trunk, Untagged

               Port e24 Access, Excluded

               OTHERS Access, Untagged

     VLAN=20, Static

               Port e12 Trunk, Tagged Port

               e24 Access, Untagged

               OTHERS Access, Excluded

     VLAN=30, Static

               Port e12 Trunk, Tagged

               Port e24 Access, Untagged

               OTHERS Access, Excluded

Ports >>> PoE

           e24 Critical

Everyone's tags (1)
CreatePlease login to create content