I am in the process of preping our network for the installation of an IP Camera based security system on it will be running within VLAN 600 in our network, and management would prefer that general users are not even aware it is there
A couple questions, is the security system the only devices on VLAN600? What is doing the routing between VLANs in your network? Depending upon how the routing is being done, you may have to setup ACLs that deny traffic to and from VLAN600 network if the general users are in a different VLAN. A little more information would be needed such as the topology and VLAN scheme being implemented to give a definitive answer. But more than likely, the device doing the routing is where the security would be applied.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...