Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LAG , how to?

Hello,

I have two serie 300 switches with 4 vlans created. I normally have one connection between two switches and configured as trunk mode with vlans added to that trunk.

Now i want to have a new connection so it will have two links between each other and i want to have a LAG so I will have 2 GB communication.

But It give me error  because those port are associated to vlans. What should i do to create that LAG, add two ports and allow vlans to communicate between switches?

thanks a lot and sorry for my ignorance.

Everyone's tags (3)
3 REPLIES
Bronze

LAG , how to?

Hello Angel,

You will want to set the ports you plan on connecting in the LAG to the same state. (same vlans same port type) Once this is done, you will do the following-

Port Management > Link Aggregation > LAG Management

Select one of the available LAGs and then hit edit

Select ports from the left side and add them to the right

Now repeat these steps on the other switch.

Once you are done they ports will be joined as one LAG.

New Member

LAG , how to?

Robert, Thanks for your reply.

After I have the LAG configure with the ports, how should I set that LAG to allowd vlans i want? like a trunk port where I set vlan allowed.

thanks.

Bronze

LAG , how to?

Yes, you will treat the new LAG as if it was just one port. You can change the LAG to trunk and add vlans just the same way.

523
Views
0
Helpful
3
Replies
CreatePlease login to create content