Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

linksys SRW208G does not run after Factory Defaults...?

I had to Restore the switch to Factory Default...now when i connect to PC via ethernet I am not able to access it.

I have HyperTerminal...I am able to connect to the switch- I tried changing the IP address but still not able to access via WEB

Please help

4 REPLIES
Green

linksys SRW208G does not run after Factory Defaults...?

Hi Chris, can you verify the HTTP access is enabled when you're using the console access?

Do you have a link light when you connect your computer to the RJ45 connection?

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

linksys SRW208G does not run after Factory Defaults...?

Yes I have both lights on.

Green

linksys SRW208G does not run after Factory Defaults...?

Okay, is the switch plugged in to your network?

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

linksys SRW208G does not run after Factory Defaults...?

Sorry for the late reply, Tom...

No the switch is plugged only in my computer...

295
Views
0
Helpful
4
Replies
CreatePlease login to create content