Hi. I've just received an SG 300 and am in the process of tuning the configuration. We have a couple of compute servers that have been behind a PIX 515e that we would like to move over to the SG 300. Is there a way to enable / configure the SG 300 to perform NAT? i.e. 192.168.1.10 gets translated to 188.8.131.52
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: