Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need help on SGH 300-20 for distributing bandwidth between vlans

Hello Every one i have some help needed

I have a cisco Swtich SGH 300-20 Gigabit switch i configure 2 vlan one is default and one is vlan 10

Vlan 1 ip range  172.16.0.0/23

Vlan 10 ip range 172.16.2.0/24

Client on Vlan getting Proper IP from DHCP Server all i need is to distribute internet bandwidth

we have 6/3 mb and i want to give 4/2 mb to vlan 1 and 2/1 mb to Vlan 10

Int Gi16 on switch is configured as trunk port and is connected to cisco 2811 router

Can any one help what are the command used to distribute bandwidth between these 2 vlans

3 REPLIES

Need help on SGH 300-20 for distributing bandwidth between vlans

Can you check and verify  the model number again please.

New Member

Need help on SGH 300-20 for distributing bandwidth between vlans

20-port Gigabit

Managed Switch

this is the model number when i logon to switch and checked from the status of swtich

but on the switch it is written     SGH 300-20 Gigabit Managed Switch

Thanks for ur reply

Need help on SGH 300-20 for distributing bandwidth between vlans

Good morning name of the user

The solution we provide

I think you are talking about a SG300-20. Let me send you a link where you could find the steps to follow in order to get this configuration.

I hope this information is useful for you.

http://www.routeralley.com/ra/docs/redundancy_load_balancing.pdf

hope you find this answer useful, if it was satisfactory for you, please mark the question as Answered.

Thank you

741
Views
0
Helpful
3
Replies