03-28-2012 11:13 PM
Hi my name is Rey Capoy. I am new to networking and got a task of configuring an SGE2010P. Our client wants us to configure mulitple VLANs on their network. I have attached a raw diagram on their network. The bottom part of the diagram shows netgear switches and on the left side is an access point. Each neatgear switch belongs to a particular department. So the first neatgear switch will be VLAN2 and the last netgeer switch will be VLAN6. The access point can be VLAN7. I was able to login to the web interface and create sample VLAN, then play with the ports but I can't get them to work. I have ask some friends and said that I will create a VLAN then assign IP address like 192.168.2.0/24 255.255.225.0. I was just wondering if how can I assign these values to a particular VLAN using the GUI or do I have to go to the CLI? I am bump into the wall right now.
Thank you very much.
Solved! Go to Solution.
03-28-2012 11:35 PM
HI Rey Capoy,
kindly go through the below admin guide :Under bridging menu it mentioned how ot configure the VLAN.
see the link below:
regards
Moorthy
03-28-2012 11:35 PM
HI Rey Capoy,
kindly go through the below admin guide :Under bridging menu it mentioned how ot configure the VLAN.
see the link below:
regards
Moorthy
04-11-2012 12:38 AM
Hi Mr. Moorthy,
I hope I am addressing you correctly. Thank you for the link. Actually I have downloaded that guide. Still doing a lot of research right now.
Have a nice day ahead.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide