I have a SG300-10MP that is connected to a Ubiquiti Gateway switch on port 1. Even though I have POE enabled the ports do not provide power over ethernet, otherwise they function normally. I have even reset the switch to the default settings without any luck. See image below for settings.
I have a second SG300-10MP connected to the one above on port 2. When I plug in the same POE device to that one it provides power.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...