I HAVE ONE LAYER-3 SWITCH.(SGE2000-CISCO SMALL BUSINESS). I HAVE THREE WEB MANAGED SWITCH.(SRRW224G4-CISCO SMALL BUSINESS)
NOW, ALL WEB MANAGED SWITCHES ARE FIXED IN THREE DIFFERENT DEPARTMENT. & LAYER-3 SWITCH IS FIXED IN CENTRAL SERVER LOCATION.
IN L-3 SWITCH, I HAVE CREATED THREE DIFFERENT VLANS & GIVEN DIFFERENT SUBNET TO EACH VLAN. NAMELY, (DEFAULT VALAN ID -100 & SUBNET IP:192.168.100.1/24) (FIRST VALAN ID -10 & SUBNET IP:192.168.10.1/24) (SECOND VALAN ID -20 & SUBNET IP:192.168.20.1/24) (THIRD VALAN ID -30 & SUBNET IP:192.168.30.1/24)
NOW, EACH DEPARTMENT SWITCH ARE ATTACHED TO L-3 AS PER THE PARTICULAR VLAN SEGMENT.
ON L-3 SWITCH, TWO SERVERS ARE ATTACHED ON DEFAULT VALAN WITH THE SAME CLASS IP & GATEWAY OF DEFAULT VLAN IP(i.e. 192.168.100.1) IN THIS CASE ALL THE PC FROM DIFFERENT VLANS ARE ABLE TO PING THE SERVER DUE TO INTRAVLAN COMMUNICATION.
******* PROBLEM: I HAVE ALSO ATTACHE ONE LINKSYS BROAD BAND ROUTER(WRT54GL) IN DEFAULT VLAN OF THE L-3 SWITCH, WITH THE IP ADDRESS OF 192.168.100.20/24. I AM NOT ABLE TO GIVE THE GATEWAY ADDRESS ON THE LAN SEGMENT OF THE ROUTER & HENCE INTRA-VLAN PCS ARE NOT ABLE TO PING THEM & NOT ABLE TO USE THE INTERNET.
********* HOW INTRA-VLAN PCS ARE ABLE TO USE INTERNET?***********
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...