I'm working on figuring out why some remote branches cannot be managed by dialing in. The line dials and appears to connect, but in the terminal nothing ever shows up.
The configuration is this:
line 0/3/0 modem InOut transport input all stopbits 1 speed 115200 flowcontrol hardware
The two bolded statements were missing, and I put them in. I thought this would solve the issue, but it has not. Our configuration seems to be the same on working routers as the configuration above. We are using 2911's with 15.1XXX if that helps.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...