Password less login with public key SSH authentication
Hello, I have a Catalyst 2960 switch (2960-8TC-L) and running Software version 12.2(53)SE1. I mange to configure SSH to the switch and add addition user as well. Now I need to configure this switch password less login with public key SSH authentication. I configured several Linux servers and Workstations for the public key SSH authentication. So far I could not figure out how to do this in CISCO switch. Following link http://blog.ioshints.info/2009/10/ssh-rsa-authentication-works-in-ios.html show how to do this. But ip ssh pubkey-chain command never work showed invalid command.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...