Once you have selected option 3, you should select the option "back", it is number 6 I believe. The device will continue to boot. Once you are at the login prompt, use admin as the login name and leave the password blank. Execute this and you should be granted access to the device. change the password immediately for the admin account as bypassing the password only works once and then the device returns to normal operation. Let me know If you have any trouble at all.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...