Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PoE on SF-300-24P to AIR-AP1231G

Hi,

I have a problem with switch SF-300-24P and AIR-AP1231G-E-K9.

The AP is working fine in a switch 2960 or 3560, and I want to move it to a new SF-300-24P.

When it is plugged in SF-300, the AP never get boot up , it obtains power, and blinks its leds, its boot process begin, but it get into a loop, and it's never gets boot up.

If I connect a external power supply to AP while it's booting, the AP gets boot up, and then it work's fine. Even, If i unplug the external power, the AP goes on working fine.

You know about this problem ? What I can do ?

BR // JI

I show you cdp of this hardware:

-------------------------

Device ID: AP3

Entry address(es):

  IP address: 192.168.3.82

Platform: cisco AIR-AP1231G-E-K9    ,  Capabilities: Trans-Bridge

Interface: FastEthernet0/8,  Port ID (outgoing port): FastEthernet0

Holdtime : 134 sec

Version :

Cisco IOS Software, C1200 Software (C1200-K9W7-M), Version 12.3(8)JED1, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2010 by Cisco Systems, Inc.

Compiled Tue 27-Apr-10 12:58 by alnguyen

advertisement version: 2

Duplex: full

Power drawn: 4.420 Watts

Power Available TLV:

    Power request id: 0, Power management id: 0, Power available: 0, Power management level: 0

Management address(es):

-------------------------

Device ID: sf-300-24p

Entry address(es):

  IP address: 192.168.3.86

Platform: Cisco SF300-24P (PID:SRW224G4P-K9)-VSD,  Capabilities: Switch IGMP

Interface: GigabitEthernet0/1,  Port ID (outgoing port): gi1

Holdtime : 153 sec

Version :

1.3.0.62

advertisement version: 2

Native VLAN: 1

Duplex: full

Power Available TLV:

    Power request id: 0, Power management id: 31980, Power available: 0, Power management level: -1

Management address(es):

show cdp neighbors detail

---------------------------------------------

Device-ID: APLINSER1

Advertisement version: 2

Platform: cisco AIR-AP1231G-E-K9

Capabilities: TransBridge

Interface: fa23, Port ID (outgoing port): FastEthernet0

Holdtime: 172

Version: Cisco IOS Software, C1200 Software (C1200-K9W7-M), Version 12.3(8)JED1, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (

Duplex: full

Power drawn: 4420 milliwatts

SysObjectID: 0.0

Addresses:

          IP 192.168.3.80

---------------------------------------------

Everyone's tags (3)
1 REPLY
Green

PoE on SF-300-24P to AIR-AP1231G

Hi Jose, please upgrade software of the switch to 1.3.5.58 then factory default it. I recommend do not use a back up config, config from scratch. This should resolve that.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
326
Views
0
Helpful
1
Replies
CreatePlease to create content