port mirroring on SRW2048 kills Wireshark workstation IP
I have a workstation on this switch that is running WireShark and I need to get packets to it. However the moment I turn on port mirroring the station loses IP connectivity to the network. I tried Rx only, Tx only and both and all three settings knock the workstation off the IP network. Is there something I am missing? Also, I noticed that I can only mirror 4 source ports to this one target port. I would like to select pretty much all the ports as source port. Why can't I do this? I was previously using an older DLink switch that allowed me to mirror all ports and I am pretty sure that other switches like the Cisco 2900 series let you select all ports as source ports.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...