Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problem in SG300 POE 28 port

Dear

i have problem in Poe port i have Access point TP link tl-wa5110g High Power when i bluged in switch i can`t take power from switch

note Acess point support Poe in put power 12V 1 A

thanks..

5 REPLIES
Green

Problem in SG300 POE 28 port

Hi Kareem, I may be defficient but I do not see POE specification for this AP?

http://www.tp-link.com/en/products/details/?model=TL-WA5110G#spec

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

Problem in SG300 POE 28 port

Dear Mr Tom

Thanks For reply but this device work poe

HARDWARE FEATURES
InterfaceOne 10/100M Ethernet Port(RJ45)
Support Passive PoE

and with this device with packge Converter and i try to connect this device by converter work fine but when i put in my switch don`t work

thanks..

Green

Problem in SG300 POE 28 port

Hi Kareem, the passive poe is not considered a standard under 802.3af since it does not have an active component. Passive POE tries to use unused wires for power.

I can only recommend you use some sort of injector to standardize your POE to be 802.3af compliant.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

Problem in SG300 POE 28 port

Dear Mr Tom

Thanks Soo Much for you support which moudel supported for my switch did you frefer

Thnaks..

Green

Problem in SG300 POE 28 port

Hi Kareem any 802.3af injector should be compatible to the switch. I'd recommend to call the AP vendor and ask them what 802.3af injector is compatible to their product.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
787
Views
0
Helpful
5
Replies
CreatePlease to create content