Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with Link Aggregation with an SG 200-26

Hello, I'm trying to setup Link Aggregation on this switch for an HP server with a 4-port NIC which is teamed.  I create the LAG and see in the HP Network Utility where each port in the team disconnects then reconnects and the server has internet access, but workstations cannot access the server (can't browse UNC, RDP, ping, etc.) and vice versa.  This is the only switch at the site, all the workstations are plugged into it.  Rebooting the switch after creating the group didn't have any effect.

Everyone's tags (2)
1 REPLY
Bronze

Problem with Link Aggregation with an SG 200-26

Hello Matt,

The SG200 LAG supports LACP as the link protocol. In order to ensure that the link will work, the teaming will also have to support this.

Another important note about LAG on this switch is that it does not use round robin for load balancing.

2214
Views
0
Helpful
1
Replies
CreatePlease login to create content