This switch has been functioning well for about 3 years. It has recently been taken out of service as it has stopped working properly. I tried getting into the management console via http. I logged in, then it goes to a page with 3 empty boxes at the top with no description of what it is requesting with a submit box with nothing inside it as well. there is no left menu system. Nothing else really to click on, other than the cisco link at the top to go to cisco.com webpage. - screen shot attached
Can i assume that it is beyond repair? or can i assume that the firmware is toast, and i need to somehow flash it?
Hi Paul, first I'd recommend to try a competely different computer, wire and port to try to manage the switch, if the same result, reset the switch by holding the rest button in for about 35 seconds. That should clear it up.
-Tom Please mark answered for helpful posts
Please mark answered for helpful posts
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...