I have a few 2960G switches I recently acquired, and I'm trying to get them to authenticate with a RADIUS server I'm running. The authentication process works fine, but though the RADIUS server is sending attributes as to which VLAN tag to use, the port stays a member of the VLAN it's set to (with "switchport access vlan ..."). I can set the guest and failed VLANs manually, but what I really want is to have the RADIUS server send VLAN attributes depending on which username or machine authenticates.
Looking through the documentation I don't see anything that specifically mentions this, so I'm afraid I purchased the wrong model. Anyone else know?
Glad to be of help, sorry for the delayed reply to your post! This one must have gotten overlooked, my appologies! We strive to provide answers and feedback as quickly as possible and usually is within 24 to 48 hrs during normal business hours. Once again sorry for the delay!
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...