I have a Cisco SG300-28P Managed Switch. After repeated attempts to reset the unit, I discovered that the reset switch had broken. There were two small pieces that appear to be an internal piece (the part that shorts the pins) and what appears to be a metal cover.
Do I have an hope of obtaining a replacement circuit board assembly ? The change out seems mindlessly simple.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...